Document Status

The following are the changes from revision 10k to 10l.

1. Page 3, clause 3, move the sentence beginning "For the purposes" after the title to subclause 3.1.

2. Pages 3 to 5, clause 3, definitions should not begin with phrases such as "This term refers to" etc.

3. Page 8, clause 5, remove the full stop after the clause number.

4. Page 8, subclause 5.2.1, line 1, replace "meters" with "m".

5. In the Introduction, item c) under the list of new low-level requirements should read: "The arbitration delay was increased from 2.2 to 2.4 us"

6. In 4.1 Overview, the last line of the fifth paragraph should read: "are contending and can be completed in less than 10 us."

7. In 8.3.3.2 Disconnect-reconnect page, there are three occurrences of 100 ms being substituted for 100 microsecond. These should all be changed to 100 us. The corrected lines should read: "The bus inactivity limit field indicates the maximum time in 100 us ...". "The disconnect time limit field indicates the minimum time in 100 us ...". "The connect time limit field indicates the maximum time in 100 us ..."

8. In 9.3.3.2 Flexible disk page, the paragraph describing the drive step rate should begin: "The drive step rate field specifies the step rate in units of 100 us."

9. In 12.2.2, paragraph 7, the reference is to Table 65, not 8.2.14.1.

10. The Foreword and Introduction clauses were modified to correctly reflect the ANSI/ISO style.

11. Updated the Vendor ID list in Annex E.